Xylem Fixed speed booster sets programming manual/Electr Instrukcja Użytkownika Pobierz pdf (Strona 50)

en en

6.2.18 HOUR COUNTER

6.2.18 HOUR COUNTER6.2.18 HOUR COUNTER

6.2.18 HOUR COUNTER

Phase Display Comment Field Default

HOUR COUNTER

HOUR COUNTERHOUR COUNTER

HOUR COUNTER

1 P1 OPERAT.HOURS Reads pump 1 operating hours 0

2 P2 OPERAT.HOURS Reads pump 2 operating hours 0

3 P3 OPERAT.HOURS Reads pump 3 operating hours 0

4 OP.HOURS RESET Resets memory of pump hour counter

7 ALARMS

7 ALARMS7 ALARMS

7 ALARMS

In MANUAL and AUTOMATIC mode the Alarms Log can be displayed by pressing the ↑UP and OK/MENU

buttons.

All the alarms are indicated and stored in the memory, but some block only automatic operation of the

set.

All the alarms cause the lighting of the red FAULT led.

The alarm for low water level on intake lights the red LOW WATER led.

Alarm display

Alarm displayAlarm display

Alarm display

The last ten alarms that occurred are stored in the board and are visible on the alarms log menu.

If an alarm occurs, the FAULT led lights up and the alarm is stored in the memory.

The alarm is shown on the display for the whole time in which the condition remains.

When the condition ceases, the alarm is automatically reset, while the blinking FAULT led remains lit.

The alarm can be acknowledged with the button P3 (EXIT): the FAULT led is turned off.

Resetting of the alarms log is done in manual mode in the Alarms menu.

ALARMS LOG MENU

ALARMS LOG MENUALARMS LOG MENU

ALARMS LOG MENU

Phase

Display Comment

0 Alarm Message 1:

Date & time

Most recent alarm

1 Alarm Message 2:

Date & time

Alarm

2 Alarm Message 3:

Date & time

Alarm

3 Alarm Message 4:

Date & time

Oldest alarm

LIST OF AL

LIST OF ALLIST OF AL

LIST OF ALARMS

ARMSARMS

ARMS

ALARMS LOG Definition Comment

MAX.PRES.THRESH.

MAXIMUM PRESSURE

ALARM

(by sensor)

Exceeding of set maximum pressure threshold for a

time greater than the defined delay.

It is active only in the mode with pressure sensor and is

excluded in manual operating mode.

If the alarm is activated for three consecutive times at

intervals of one minute, the board inhibits the

automatic operation; a manual reset is required

INFORMATION FOR THE INSTALLER AND USER

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 167 168

Komentarze do niniejszej Instrukcji

Brak uwag

Xylem Fixed speed booster sets programming manual/Electr Instrukcja Użytkownika Strona 50

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Pompy Xylem Fixed speed booster sets programming manual/Electr